HOME       l       PRODUCTS       l       PROJECTS       l       SERVICE       l       ABOUT       l       CONTACT

INDUSTRIAL  AUTOMATION  SPECIALISTS

Copyright © Raptor Integration Inc.  

OUR MISSION:

To provide on-time, on-budget technology solutions, that safely deliver process throughput and quality improvements.

+ QUALITY ASSURANCE

+ SOCIAL RESPONSIBILITY

+ HEALTH & SAFETY

+ ASSOCIATES

RAPTOR INTEGRATION INC.

6290 50 St NE,
Canoe, BC
V1E 4P5
Tel:  1-888-734-2659

RS End Scan inspects the short end of the board and delivers information about its properties. The system can be configured in 2 different ways:

1) Detection of position in the cut pattern for boards based on the pith. A high resolution photo is recorded and gives the system an exact map of the visible annual rings. The pith position is given by analyzing the annual rings and calculating the distance to the pith if it’s not visible.

2) Up and downside detection of boards based on the visibility of annual rings on the short end. A high resolution photo is recorded and analyzed and the system delivers information about which side of the board is turned up or down. The system has a very high hit rate as long as the annual rings are visible. Dirty, uncut or knot filled board ends gives an inferior result, but more than often the result will be correct even with these type of boards.

Simple adjustments makes it easy to set the properties identifying inner or outer boards.

RS End Scan Gives You: